Arducam B0279 for Jetson IMX477 HQ Camera Board

Arducam B0279 for Jetson IMX477 HQ Camera Board

Artnr.: AC2-202790
Hersteller: Arducam

Arducam for Jetson IMX477 HQ Camera Board, 12.3MP Camera Board for Nvidia Jetson Nano/Xavier NX

71,90 €

inkl. 19% MwSt.

(60,42 € exkl. MwSt.)

zzgl.

ab Lager lieferbar (knapper Bestand)

Beschreibung
Kundenrezensionen

Arducam just released this High Quality camera module for Jetson Nano/Xavier NX, an IMX477 camera board with 3 hole pitches. You can use this camera module on Jetson Nano/Xavier NX natively with ISP features. No hardware modifications required, just install the driver and you are good to go.

NOTE: This camera is mainly designed for the Jetson Nano. It can also be used on the Raspberry Pi Compute Module (like CM3, CM3+), but is not compatible with standard Raspberry Pi models (like Raspberry Pi 3/3B+/4).

A Can't-Miss Update to IMX219 - Much better picture quality and lens flexibility, thanks to 53% more pixels, 92% larger pixel size, 192% larger imaging area, and a CS-Mount. Maximum still resolution at 4056 × 3040, frame rates: 30fps@Full 12.3MP, 60fps@1080P. NOTE:
Accelerated by Jetson Hardware ISP Engine - Support NVIDIA Argus Camera plugin for H264 encoding, JPEG snapshots, as well as gain, exposure, framerate, and group, hold control.
Only a driver away from Plug-and-Play - The Raspberry Pi HQ camera module requires hardware modification before installing the Jetson IMX477 driver, which could bring potential damage and void the warranty. Ours don't.
4-Lane Camera for the Future - Route out all 4 data lanes to the camera connector for customized carrier boards with 4-lane CSI connector and future 4-lane camera driver updates.

Sensor: IMX477
Optical Format: 1/2.3" (diagonal 7.857mm)
Resolution: 4056(H) x 3040(V) 12.3MP
Pixel Size: 1.55um x 1.55um
IR Sensitivity: Visible light
Interface: 4-lane MIPI CSI-2
Default Lens Mount: CS-Mount
Frame Rate: Due to Jetson Xavier NX/Nano hardware only supports 4K@30fps h.264/h.265 encoding, you cannot use it for 4K@60fps.

Board Size: 38mm×38mm
Hole Pitch: Compatible with 29mm, 30mm, 34mm

Note: For the new version(R32 4.4), please refer to the following link:
https://github.com/ArduCAM/MIPI_Camera/releases

3D drawing

1pcs 12.3MP IMX477 camera board with dust cap for Jetsons
1pcs 11.8"(30cm) camera cable

C/CS Lens is NOT INCLUDED.
Pi 2/3/4/Zero WON'T WORK WITH IT. ONLY THE COMPUTE MODULES DO.
The camera driver MUST be installed: https://github.com/ArduCAM/MIPI_Camera/tree/master/Jetson/IMX477/driver
It can't work on the standard Raspberry Pi models (like Raspberry Pi 3/3B+/4).
This camera can just be supported by Jetson nano and Xavier NX at present, any other Jetson boards will not be supported.

Versandgewicht:	0,03 kg

Es gibt noch keine Bewertungen.