Arducam B0283 Upgraded Camera Pan Tilt Platform for Raspberry Pi

Arducam B0283 is a new member of the family, which is an upgraded version of B0227 with improved bracket quality and a mini customized control board. It can move the camera for pan and tilt directional control, and that means a single camera can be used to monitor places that should be covered by multiple ones.

• Upgraded: 1. Increase the quality of bracket; 2. Customize a smaller board which can be enclosed in the base; 3. Extend the vertical rotation angle from 145 degree to 180 degree.
• Pan Tilt Kit: Free panning and tilting in a smaller PT bracket. Specifically designed for a broader view on Raspberry Pi camera projects, can also be used on Jetson NX and other platforms (RPi demo only).
• Customized Control Board: I2C controlled, outputs the PWM signals to drive the servo motors directly, aesthetic and minimalist customization design makes it can be mounted in the base bracket and simplify the wiring.
• Mini Digital Servos: Two GH-S37D digital servos for a faster speed, higher torque and better holding capability (than analog servos).
• You'll be Getting: 1 set pan tilt bracket kit, 2 digital servo motors, a PTZ controller board (with 4 jumper wires), a pack of screws.

Digital Servo

• Torque: 0.6 kg/cm at 3.6V, 0.8 kg/cm at 4.8V
• Operating Speed: 0.13sec/60° at 3.6V, 0.09sec/60° at 4.8V
• Operating Voltage: 3.6v~4.8v
• Operating Current:
• Dead Band: 3 usec
• Dimension: 20mm x 8.75mm x 22mm

Customized Control Board

• PWM resolution: 12-bit
• Communication interface: I2C
• Operating voltage: 3V-5V
• Dimension: 38mm x 28mm

• 2 x Digital servos
• 1 set upgraded bracket pieces
• 1 x Customized control board
• 4 x Female to female jumper wires (The wire has no fixed color)
• 1 x Screws pack
• 1 x Manual

3D Drawing

User Guide