This passive high-impedance oscilloscope probe is suitable for most oscilloscopes with a 1 MΩ input impedance.
*The probes can continue to measure above the rated bandwidth but with decreased signal, the probe will reach the f3dB limit above the rated bandwidth. The probe has a flatness of ±0.5dB over the first 1/3 of the bandwidth and less than ±3dB over the specified bandwidth.
|
SP100 |
SP200 |
| Bandwidth >= f3dB (MHz)* |
DC to 100 MHz |
DC to 200 MHz |
| Rise time (ns), alculated |
3.2 |
1.75 |
| Attenuation Ratio |
10:1 |
| Input Resistance (MΩ), ± 2% |
10 |
| Input Capacitance (pF) |
10 - 14 |
| Full-scale measurement range |
Voltage: +/-60 V DC, 30 V AC RMS, +/-42.4 V pk max. |
| Overvoltage protection(voltage that will not damage) |
200 V DC + peak AC |
| Compensation Range (pF) |
15 - 45 |
| Cable length with BNC |
1.1m |
0.8m |
| Operating Environment, Max. altitude 2 km |
-20 to +60 °C, 0 to 80% RH |
| Storage Environment, Max. altitude 15 km |
-20 to +60 °C, 0 to 80% RH |
| Probe tip diameter (mm) |
0.5 |
| Pollution Degree |
2 (As defined in IEC 61010-031. Only non-conductive pollution. Occasionally, however, a temporary conductivity caused by condensation must be accepted.) |
| RoHS and REACH compliant |
Yes |
There are no reviews yet.
This video cannot be played. Following video types are supported: .mp4, .ogg and .webm .