Waveshare 10053 ST-LINK/V2 (mini)

In-Circuit Debugger und Programmierer für STM8 und STM32 MCUs; mit IAR EWARM und Keil RVMDK und ST toolset

19,90 €

inkl. 19% MwSt.

(16,72 € exkl. MwSt.)

zzgl.

Description

Mini ST-LINK/V2 on a small single board, an extreme low cost solution for in-circuit debugger/programmer for STM8 and STM32.

Onboard 500mA self-recovery fuse to avoid harming by short circuit
Dual voltage output (3.3V/5V), easy for debugging/programming
Standard USB interface for direct connection to PC
Debugging/Programing performance
- Debugging : run at full-speed, single-stepped, breakpoints, viewing variables and registers, etc.
- Programming : supports FLASH ROM, EEPROM, AFR, etc.
- USB2.0 combined with SWIM/SWD interfaces : quick response for debugging & fast speed for programming
Upgradable firmware
- The firmware is upgradable to support more devices in the future
- Automatically upgraded
Supported software
- ST-LINK Utility v2.0 (or higher ver.)
- STVD Version 4.2.1 (or higher ver.)
- STVP Version 3.2.3 (or higher ver.)
- IAR EWARM Revision v6.20 (or higher ver.)
- IAR EWSTM8 Revision v1.30 (or higher ver.)
- KEIL RVMDK Revision v4.21 (or higher ver.)
- ATOLLIC
- TASKING
Supported devices
- All the STM8 devices with SWIM interface
- All the STM32 devices with SWD interface

Compare	ST-LINK/V2 (mini)	ST-LINK/V2	ST-LINK	Remarks
SWD voltage range	1.65V - 3.6V	1.65V - 3.6V	3V - 3.6V	ST-LINK/V2 and ST-LINK/V2 (mini) support STM32 low voltage devices
SWIM voltage range	1.65V - 5.5V	1.65V - 5.5V	1.65V - 5.5V
Supports SWV	NO	YES	NO	For the moment, only STM32 supports SWV while STM8 doesn't
Debug interfaces	2	2	1	ST-LINK/V2 and ST-LINK/V2 (mini) support STM8/STM32 with separated interfaces
LED indicator	Dual color LED	Dual color LED	Red LED	Dual color LED allows indicating more status
Fuse	YES	NO	NO	Fuse for avoid harming by short circuit

While connecting the ST-LINK/V2 (mini) to the computer through USB interface, the USB driver is required and should be installed correctly first.

The ST-LINK/V2 (mini) should be connected to the STM8 application via the SWIM interface.

The ST-LINK/V2 (mini) should be connected to the STM32 application via the SWD interface.

Please note that the VCC and GND should be connected correctly to avoid any harm to the ST-LINK/V2 (mini).

Wiki: www.waveshare.com/wiki/ST-LINK/V2_(mini)

Versandgewicht:	0,08 kg

Es gibt noch keine Bewertungen.