Waveshare 5989 USB Blaster V2

Artnr.: WS1-005989
GTIN: 0700646949670
Hersteller: Waveshare

Waveshare USB Blaster V2 Download Kabel, kompatibel mit ALTERA USB Blaster FPGA/CPLD Programmierer, Hochgeschwindigkeitslösung FT245+CPLD

34,90 €

inkl. 19% MwSt.

(29,33 € exkl. MwSt.)

zzgl.

ab Lager lieferbar (knapper Bestand)

Description

The USB Blaster Download Cable interfaces a USB port on a host computer to an Altera® FPGA mounted on a printed circuit board. The cable sends configuration data from the PC to a standard 10-pin header connected to the FPGA. You can use the USB Blaster cable to iteratively download configuration data to a system during prototyping or to program data into the system during production.

It surpports most of the ALTERA FPGA/CPLD devices, Active Serial Configuration devices, Enhanced Configuration devices, and supports AS, PS, JTAG three download modes.

Key Features

Hardware Solution
- High speed FT245+CPLD+244 solution, similar download speed as the original ALTERA USB Blaster, with the same operation.
- Download speed 1-3 times faster than other schemes, such as 68013 or C8051F.
Performance
- Supports most of the ALTERA FPGA/CPLD devices, Active Serial Configuration devices, and Enhanced Configuration Devices.
- Supports AS, PS, JTAG three download modes.
- High-speed, stable, and internal FT245R+CPLD designed.
- Supports 1.2-5V programming voltage.
- Supports SignalTap II embedded logic analyzer.
- Supports Nios II of embedded processor communication and debugging.
Supported Softwares
- Quartus II integrated development environment.
- NIOS II IDE integrated development environment.
- NIOS II EDS integrated development environment.
Supported Devices Tested devices are listed below, including but not limited to:
- CPLD: MAX3000, MAX7000A/B/S, MAX9000 and MAX II etc.
- FPGA: Stratix, Stratix II, Cyclone, Cyclone II, CycloneIII, ACEX 1K, APEX 20K and FLEX 10K etc.
- Active Serial Configuration Devices including: EPCS1, EPCS4, EPCS16 etc.
- Enhanced Configuration Devices including: EPC1, EPC4 etc.
Connects to PC
- Computer connection via USB 2.0 interface.
Connects to target board
- Target board connection via JTAG, AS, PS interfaces. The figure 1, 2,and 3 below shows the header pinouts of different interfaces.
Figure 1. JTAG header pinout

Figure 2. AS header pinout

Figure 3. PS header pinout